Jack/MIDI transport sync

Post Reply
knochjoch
Posts: 6
Joined: Sat Jul 24, 2021 6:18 pm

Jack/MIDI transport sync

Post by knochjoch »

Hello again,
Could someone please explain how to set up the jack transport sync for syncing several daws including the song position?
I can't seem to find a setting for it, only for midi transport.
Last edited by knochjoch on Thu Aug 26, 2021 9:07 pm, edited 1 time in total.
User avatar
NightRadio
Site Admin
Posts: 3941
Joined: Fri Jan 23, 2004 12:28 am
Location: Ekaterinburg. Russia
Contact:

Re: Jack transport sync

Post by NightRadio »

It is not supported yet, sorry.
SunVox can receive SYNC (start/stop, tempo, position) commands from MIDI sources, or from the AU host (iOS only).
You can turn it on/off in the Main Menu -> Project Properties -> Sync.
In some external host, enable MIDI sync output, and choose one of the SunVox MIDI input ports as destination
knochjoch
Posts: 6
Joined: Sat Jul 24, 2021 6:18 pm

Re: Jack transport sync

Post by knochjoch »

Ah ok, thanks though (a lot for your software too :))!
Will see if I can get it running that way (on linux).
I think i remember that Renoise sending the wrong commands concerning position was why i gave up last time i tried (or the other way around or something like that...^^'), but its been a while ago and it should be possible to work around that anyway. Need to look into it again...
knochjoch
Posts: 6
Joined: Sat Jul 24, 2021 6:18 pm

Re: Jack transport sync

Post by knochjoch »

Aha!... Project properties...^^"
thorough reading helps...
Feeling a little dumb but it works like a charm.
Thanks!
Post Reply