idk whether to put this here or the bugs subforum, but whatever
i have a behringer fcb1010 midi foot controller (it does the job, despite the crappy leadership on behringer's part), but for some reason when i adjust either of the two pedals it sends a signal to sunvox to play the project? it's really annoying and makes it unusable for me, especially in a potential live setting
i don't believe the signal is configured that way in the shortcuts, i may have to check the config though. where would that shortcut be in the config, if anywhere else?
thank you
behringer fcb1010 pedals send project play signal
- AutumnCheney
- Posts: 507
- Joined: Sun Dec 29, 2019 8:16 am
- Location: tahlequah, ok, usa
- Contact:
- AutumnCheney
- Posts: 507
- Joined: Sun Dec 29, 2019 8:16 am
- Location: tahlequah, ok, usa
- Contact:
Re: behringer fcb1010 pedals send project play signal
i should now mention that i already tried resetting the unit, and that the signals that the two pedals normally send are cc27 and cc7 on channel 1, respectively
- AutumnCheney
- Posts: 507
- Joined: Sun Dec 29, 2019 8:16 am
- Location: tahlequah, ok, usa
- Contact:
Re: behringer fcb1010 pedals send project play signal
also, this only happens with sunvox, ardour doesn't do this, and i imagine neither would any other program on my system
- AutumnCheney
- Posts: 507
- Joined: Sun Dec 29, 2019 8:16 am
- Location: tahlequah, ok, usa
- Contact:
Re: behringer fcb1010 pedals send project play signal
so i remembered i had midisnoop installed; i ran it, and i'm getting "midi start/continue" messages when i adjust the pedal
so i guess it's a problem with the pedal
so i guess it's a problem with the pedal
- AutumnCheney
- Posts: 507
- Joined: Sun Dec 29, 2019 8:16 am
- Location: tahlequah, ok, usa
- Contact:
Re: behringer fcb1010 pedals send project play signal
ah, i can turn off midi sync in the midi menu in the preferences! wow, can't believe the solution was that simple
hopefully i won't ever actually need midi sync
hopefully i won't ever actually need midi sync