Send system messages to MIDI
Posted: Fri Jul 01, 2016 7:08 am
Hello everyone.
I'm new to the forum, but have been experimenting with SunVox for one month or so.
I got this sweet little device named Pocket C.H.I.P. that comes bundled with a setup of SunVox included by default.
I'm enjoying the software, and I find it fascinating.
I also have this other little device named Pocket Miku, which is basically a voice synth with an embedded voice in the chip, made by Yamaha and containing the voice samples of the virtual idol Hatsune Miku.
It works as a USB MIDI Controller and it is detected properly by the Pocket CHIP and SunVox.
In this tweet I pictured both devices: https://t.co/nHomDTSwGe and out of the box: https://t.co/JLwqCNE7RN
As mentioned, Pocket Miku contains a lot of samples, including one for each of the syllables of Japanese language.
However, the only way to change the syllable used is with a system command of this particular data:
0xF0, 0x43, 0x79, 0x09, 0x11, 0x0A, 0x00, <an identifier for the syllable to use>, 0xF7
Using other software I've been able to send the command, including a sample page in NSX39 official website.
But I havent found the option to send a sysmsg in SunVox.
Is there a way? Because I love how the tracker works in this software!
Keep up the good work, and hope there are good news!
I'm new to the forum, but have been experimenting with SunVox for one month or so.
I got this sweet little device named Pocket C.H.I.P. that comes bundled with a setup of SunVox included by default.
I'm enjoying the software, and I find it fascinating.
I also have this other little device named Pocket Miku, which is basically a voice synth with an embedded voice in the chip, made by Yamaha and containing the voice samples of the virtual idol Hatsune Miku.
It works as a USB MIDI Controller and it is detected properly by the Pocket CHIP and SunVox.
In this tweet I pictured both devices: https://t.co/nHomDTSwGe and out of the box: https://t.co/JLwqCNE7RN
As mentioned, Pocket Miku contains a lot of samples, including one for each of the syllables of Japanese language.
However, the only way to change the syllable used is with a system command of this particular data:
0xF0, 0x43, 0x79, 0x09, 0x11, 0x0A, 0x00, <an identifier for the syllable to use>, 0xF7
Using other software I've been able to send the command, including a sample page in NSX39 official website.
But I havent found the option to send a sysmsg in SunVox.
Is there a way? Because I love how the tracker works in this software!
Keep up the good work, and hope there are good news!