Page 1 of 1

Filter Impulse control

Posted: Fri May 26, 2017 10:21 pm
by 800A
Hi everybody,
I made a simple patch with a generator going into a filter and then to the output.

My problem is that if a try to play notes setting lets say the filter freq half way and the impulse at 25% and try different values for the Response,
I don't hear any changes in the filter freq. I hear exactly only the freq that is already set.

On the other hand the automation works, but I would like to just set a value and not to write on each line.

Am I missing something?


Re: Filter Impulse control

Posted: Sun May 28, 2017 3:39 pm
by SawZer
The impulse command is only for pattern use. The impulse happens instantaneously upon hitting the command.

How does impulse work? It's simple a sharp rise in frequency that will fall back to the cutoff frequency based on the response value.
You can't just "set" it.

Re: Filter Impulse control

Posted: Sun May 28, 2017 4:10 pm
by Elfferich
It's just like phase parameters in modules like filters, LFO's etc. It won't stay the same.

Re: Filter Impulse control

Posted: Mon May 29, 2017 10:38 pm
by 800A
Oh now I see!
Thanks for the help guys :friends: