Accurate LFO Phase

Post Reply
Trickle
Posts: 5
Joined: Mon Jul 10, 2017 7:54 am

Accurate LFO Phase

Post by Trickle » Mon Jul 10, 2017 8:38 am

I noticed that the phase in SunVox's LFO "slides" when it oscillates. The LFO always starts on a new phase whenever a note ends or begins. So, is there a way to accurately start, and end, on the same phase? or is there a way to work around this?

User avatar
NightRadio
Site Admin
Posts: 2860
Joined: Fri Jan 23, 2004 12:28 am
Location: Ekaterinburg. Russia
Contact:

Re: Accurate LFO Phase

Post by NightRadio » Mon Jul 10, 2017 2:02 pm

The LFO always starts on a new phase whenever a note ends or begins.
Exactly, because the LFO phase is independent parameter :) It never stops.
Use the "Set phase" controller to change the phase value.

Trickle
Posts: 5
Joined: Mon Jul 10, 2017 7:54 am

Re: Accurate LFO Phase

Post by Trickle » Tue Jul 11, 2017 3:12 am

Hmm, how do I use this "Set phase" controller? I'm not too familiar with this controller on the LFO module, so can you briefly explain its usage? Thanks for the speedy reply.

User avatar
NightRadio
Site Admin
Posts: 2860
Joined: Fri Jan 23, 2004 12:28 am
Location: Ekaterinburg. Russia
Contact:

Re: Accurate LFO Phase

Post by NightRadio » Tue Jul 11, 2017 1:29 pm

Just set it :)
For example, in some line of the pattern, change the "Set phase" controller to some value. For example, to 128:

Code: Select all

NNVVMMCCEEXXYY
....1206004000
Then play this pattern. And the line (described above) will reset the phase of your LFO to 128.
Min phase value is 0. Max is 256.

Trickle
Posts: 5
Joined: Mon Jul 10, 2017 7:54 am

Re: Accurate LFO Phase

Post by Trickle » Thu Jul 13, 2017 6:21 am

Ah, I see. Thanks for the extra help. I think I understand the SunVox LFO a bit better now. Thanks again, NightRadio.

Post Reply