supersimple feature request: dry-fader on compressor

User avatar
leondustar
Posts: 5
Joined: Tue Feb 28, 2017 12:40 am

supersimple feature request: dry-fader on compressor

Postby leondustar » Sun Mar 19, 2017 3:59 pm

The compressor introduces a small signal latency, which makes it hard to do parallel compression.
(Just adding the dry signal to the compressor output causes phase-artifacts)

Solution: put a 'dry' slider on the compressor to mix-in some dry-signal into the wet

Parallel/bus compression is great to emphasize peaks in compressed signals.

iaon
Posts: 181
Joined: Mon Jun 02, 2014 7:56 am

Re: supersimple feature request: dry-fader on compressor

Postby iaon » Mon Mar 20, 2017 12:11 am

Just a thought: If this Dry controller could go both ways—adding or subtracting the dry signal without latency—it could also be used to get the gating behaviour that has been made into a few MetaModules. Alternatively 'Gate' could be a third Mode or perhaps even a new Gate Module with similar visuals.

TheBlu30ne
Posts: 12
Joined: Thu Sep 22, 2016 11:03 pm

Re: supersimple feature request: dry-fader on compressor

Postby TheBlu30ne » Sat Apr 15, 2017 2:10 am

leondustar wrote:The compressor introduces a small signal latency, which makes it hard to do parallel compression.
(Just adding the dry signal to the compressor output causes phase-artifacts)

Solution: put a 'dry' slider on the compressor to mix-in some dry-signal into the wet

Parallel/bus compression is great to emphasize peaks in compressed signals.


Can't you do this by just:

Input -> Compressor -> output
\--> Dry ----------------/^

And just multictl the dry and wet to the volumes to make it easier. This should do it right?


Return to “SunVox Feature Requests”

Who is online

Users browsing this forum: No registered users and 1 guest